Rotational Viscometer design proceeding apace
It’s been a while since I’ve worked at full steam on the viscometer project. Though now a long way from it’s DIY roots I am making this new version from mostly Aluminum, Phenolic, Nylon and Low Density PolyEthylene. I had to scrap the last version since it would have been too difficult to actually assemble, this one is a little different in it’s overall size and assembly.
-
- With the keypad removed
-
- From the front
-
- From the front
-
- Drawing version
Of course it isn’t finished yet as it doesn’t have the screen and top switch attached as well as the outer shell. Perhaps I’ll start making it this week sometime.
The Amp Hour Radio Show