Anyways, as I promised, here is the almost finished. A couple days later than I said but, still, I did finish it for the most part.
So Basically what we have here is a $20 lamp that’s been outfitted with buttons to control its power status. I have to warn people first, the methodology of affixing the stuff in here is very sloppy. If you follow these methods of hot gluing stuff, use caution to support the boards in other ways.
As you can see, I busted the box off of a wall wart to use as the power supply and used a terminal block to handle all of the mains stuff. It got pretty crowded in the enclosure so I’ll have to make a new cover for the bottom. Also, without the weight that was inside of it, it’ll topple. Anyways, it seems to work well.
So, after this is all done and a cover is made, I’ll also have to secure all of the boards a bit better and cut the prongs off of the wall wart, That’s a tad bit dangerous to have those prongs exposed.
So, whenever I get around to part three, I’ll take some pics and show them. Thus ends one application for the PIC10F200.
As an aside, I’ve been doing some of the work at a local hackerspace here in Edmonton. I was extremely surprised to find one here in Edmonton, land of the rednecks! Well, here are some pics of the place. It’s only been around for two years and could always use some new members.
Here it is on the outside, nothing to make note of here.
And here is the inside of the common area of the ENTS.
Pretty messy, but that goes with the territory of a shared common use area I suppose. If anyone is interested, visit Ents.ca here in Edmonton.