An update on the ol’ measuring tool

The prototype gage and the gage ring. looking good so far.
The prototype gage and the gage ring. looking good so far.

Well, it’s coming along with some speed. I am now going to build the final version complete with internal battery charging, better logic and a severe reduction in mass. Hopefully this will go down well with the customer.

The display of the gage. the large 18650 batteries are housed in the right hand side. This will be rectified in later versions.
The display of the gage. the large 18650 batteries are housed in the right hand side. This will be rectified in later versions.

Anyways, this post was for posterity. As always I hope it turns out well. 🙂

One thought on “An update on the ol’ measuring tool”

  1. Hi,

    I love your project, also i would like make the same project, but i don’t very good in programmation…
    could you tell me if it’s possible to send me your schematic and program of your ardruino to make the same, please ?

    very good job !!

Leave a Reply

Your email address will not be published. Required fields are marked *

Security Code: